Aluminum Paint STP Silver Shield

SuperSilverShield® is an anti-corrosive, water proofing paint with aluminium finish SuperSilverShield® is composed of oxidized bitumen, solvents and specially formulated aluminum compound. Characteristics Finish Silver Drying Time, hr 5 DFT / coat, Micron 30 to 40 Specific Gravity 0.96 Theoretical Coverage*, m2 / L • On metal and old painted surfaces • On bituminous surfaces • On brick masonry and concrete 10 ± 1 8 ± 1 6 ± 1 Consistency Smooth, Uniform, Brush-able * Depending on surface condition Application SuperSilverShield® is used as a protective coating on iron, steel, masonry and other surfaces. Advantages • Deflects UV rays and thus prevents degradation of membrane due to exposure to sunlight. • Facilitates heat insulation. Application Methodology Surface Preparation • Remove dust, flakes, oil, grease or other foreign particles by jet or dry air and clean the surface before applying SuperSilverShield®. • Undercoat is not necessary for its application. Material Preparation • Stir SuperSilverShield® by a slow speed mixture (approx. 400 rpm) fitted with a suitable mixing paddle to ensure thorough dispersion of aluminium for a uniform finish. Application of Material • Apply SuperSilverShield® on the prepared surface by brush. • Allow it to dry for 5 hr. • SuperSilverShield® can be applied over old painted surfaces without burning off or scraping, provided the old surface is not in a flaky condition. Health & Safety • Avoid contact with skin / eyes and avoid swallowing. • Ensure adequate ventilation and avoid inhalation of vapour. • Wear suitable protective clothing, gloves and eye protection. • In case of skin contact, rinse with plenty of clean water, then cleanse with soap and water. Do not use solvent to clean the contacted area. • In case of eye contact, wash with plenty of clean water and seek medical advice. • If swallowed, seek medical attention immediately. Do not induce vomiting.