MYK LATECRETE LATAPOXY 310 SPOT BONDING TILE ADHESIVE
₹1,280
Seller : CIVILIZE MART
Specification
- color
- Off White
- open time
- Extended
- tile type
- Porcelain Tile, Marble, Ceramic Tile, Vitrified Tile, Granite
- availability
- In Stock
- adhesive class
- R2
- application area
- Wall
- suitable location
- Indoor & Outdoor
Add Quantity
Description
91 000 74051 It's a two-component, high-strength epoxy adhesive / chemical anchoring bonding — not a simple cement-tile adhesive. It's designed for "spot bonding" — meaning you use dab/spots of this adhesive on the back of marble / stone / tile pieces, then press them onto vertical or overhead surfaces (walls, facades, etc.). It's especially used for natural stone, marble, granite, heavy tiles, large-format ceramic/slate work — anything where a strong, permanent, non-sag bond is required. �� Key Features & Advantages Strong permanent bond — once cured, the bond is very durable. Fast set time — standard version sets in ~45–60 minutes. Non-sag consistency — you can apply it on walls/vertical surfaces (even overhead), and it won't drip or run. Non-staining — safe for light-coloured stones, tiles, marble, so it doesn't leave visible adhesive marks. Resistant to shock, vibration, moisture, damp surfaces — good for exposed facades, external walls, or areas subject to stress. No mechanical anchors/clamps required — simplifies installation compared to mechanical fixing or continuous bedding adhesives. �� Where & When It's Generally Used Suitable for: Bonding marble, granite, natural stone slabs, large-format ceramic tiles on walls, facades, vertical surfaces, and overheads (e.g. cladding walls, exterior finishes). Fixing heavy stone/veneer slabs in places like stair risers, elevator lobbies, fireplace surrounds, exterior facades — anywhere regular thin-set adhesive might fail. Situations needing strong structural bonding rather than just surface-level tile adhesion (especially with heavy or large stones). �� How to Use It (Basics) It comes in two parts (Part A + Part B). Mix in 1:1 ratio by volume until uniform. Apply "spot-dabs" on the back of stone/tile (not full bed), then press onto prepared, clean surfaces (concrete, masonry, cement-backer board, steel, plywood, etc.). Good for vertical or overhead — due to non-sag property — and suitable even for exterior or damp surfaces (provided substrate is prepared properly).