Electric Single Plastic Shower Welding Machine

The Electric Single Plastic Shower Welding Machine welds plastic shower parts with repeatable heat and pressure so every joint stays sealed. A frame of mild steel plate and square tube supports the heater, cylinder plus control box - the paint finish resists rust in damp plants. The operator plugs the cord into a 220 V, 50 Hz single phase outlet - no extra transformer is required. A PLC starts the heater, clamps the parts, times the weld, cools the joint and releases the fixture without further input. The same temperature appears at each cycle - the bead width and strength stay constant on PVC, ABS or PP components. Power draw peaks at 1.8 kW but also drops once the set point is reached keeping running costs low on long production runs. Hinged guards swing open - the heater band besides Teflon strips swap out in minutes - downtime stays short. The footprint measures 600 mm × 400 mm - four M8 holes in the base plate bolt the unit to a bench or conveyor line. Units sit packed and ready in the warehouse - shipment follows the same day once the order clears.